These GPU’S are designed for ground use to perform starting and maintenance functions and are built with a 300 amp power supply. When connected to AC power, the depleted batteries can be charged in less than two hours with the built in power supply/battery charger.

START PAC MODEL 3324-2
SPECIFICATIONS AND INFORMATION

The Model 3324-2 GPU is a combination power supply and battery pack.

The following dimensions apply to each of the 3300s:
38"x21"x20" Handle Height 48".

Features- The GPU is rated at 2400 peak starting amps and a continuous 300 amps DC output when connected to a 220 Volt AC source. This unit is ideally suited to power up such aircraft as the Phenom 100 and the Phenom 300 which have very large AC units and require a GPU capable of 300 amps continuous.

The 3324-2 weighs 200 Lbs. and is pulled by hand or tug. Locking the handle in an upright position sets the GPU brake.

Always recharge the GPU until charger green light appears. Once charged, it is not necessary to leave the unit turned on. Leave unit plugged in to the AC source when not in use.

*** There are approximately 30 110 volt and 30 220 volt NEMA plugs in use. ***
Also, customers have various receptacle at their hangars and MRO facilities
and may require specific AC cord length to meet their requirements.
Due to these facts, we do not automatically provide AC power cords.
If you provide the NEMA plug number and specify the AC power cord length
you require we will build a cord to be shipped with your unit for a small fee.

NOTE-PLEASE USE #12 or LARGER AC EXTENSION CABLE

For technical assistance, contact Jim Wurth, chief engineer, directly at (928) 231-4536 or jim@startpac.com.