OPERATING
INSTRUCTIONS
1. Check fuel
and oil levels before every use.
2. Set the throttle to half-way up position.
3. Turn the ignition key to start the engine and choke if necessary.
4. Allow the engine to warm up for a few minutes.
5. Plug power plug (3-pin connector) into aircraft.
CAUTION:
Make sure that the aircraft systems are shut down.
6. Accelerate
the engine to 3600-3650 rpm by moving the throttle upwards.
Now the aircraft systems can be turned on. The engine and generator
provide the continuous power required for the aircraft systems and
the batteries provide the necessary power for engine starting. It
is not necessary to run the engine for starting capabilities.
7. After starting, the engine should be left funning for approximately
10 minutes to recharge the starting batteries.
8. When finished charging or powering up aircraft systems, the engine
should be run at idle for a few minutes before shutting down.
9. For maximum life, the batteries should be kept charged to 100%
when not in use.
10. Follow service instructions in the Kohler engine owner’s
manual.
All Start Pac®
products come with a 1-year warranty on workmanship and materials.
Batteries are cycle-dependent and therefore are not covered under
this warranty. Cost for premature failure of batteries can be calculated
using the following formula:
Initial cost
of batteries x time used (in months)¸ 12 (months) = Replacement
Cost
Please handle
this unit in a responsible manner. Start Pac®
is not responsible for damages caused by misuse or neglect.
For
technical assistance, contact Jim Wurth, chief engineer, directly
at (928) 231-4536 or jim@startpac.com.
Start Pac is
a registered brand and Hi-Brd is a trademark name both under Rotorcraft
Enterprises, LLC.
|